Details when the emulsified bitumen equipment is used for the first time
1. After the emulsified bitumen equipment is installed in place, please check whether the connections of each part are firm and tight, whether the operating parts are flexible, whether the pipelines are unobstructed, and whether the power wiring is correct.
2. When loading bitumen for the first time, please open the exhaust valve to allow the bitumen to enter the heater smoothly. hengtlq.sh26.host.35.com

3. Before ignition, please fill the water tank with water, open the valve to reach the water level in the steam generator, and close the valve.
4. During operation, please pay attention to observe the water level and adjust the valve to keep the water level in the proper position for a long time.
5. If there is water in the bitumen, please open the top of the tank when the temperature is 100 degrees and start the internal circulation dehydration.
6. After dehydration, please pay attention to the indication of the thermometer and pump out the high-temperature bitumen in time. If the temperature is too high and does not need to be displayed, please start the internal circulation cooling immediately.
7. When the bitumen level in the tank is lower than the position of the thermometer, please close the suction valves before stopping the emulsified bitumen equipment to prevent the bitumen in the heater from flowing back.
8. To save fuel and equipment operation, please add less coal, add coal frequently, and dispose of ash in time.