Slow cracking and fast setting micro surface emulsified asphalt
Customer Support
Your Position: Home > Blog > Industry Blog
Slow cracking and fast setting micro surface emulsified asphalt
Release Time:2024-02-21
Emulsified asphalt for micro surfacing is the binding material for micro surfacing construction. Its characteristic is that it needs to meet the mixing time with the stone and the opening time for traffic after the paving is completed. To put it simply, it meets two time issues. The mixing time must be sufficient, and the opening of traffic must be fast, that's all.
Let’s talk about emulsified asphalt again. Emulsified asphalt is an oil-in-water asphalt emulsion. It is a uniformly viscous liquid at room temperature. It can be applied coldly and does not require heating. It is energy-saving and environmentally friendly. Emulsified asphalt is divided into three types according to the different asphalt emulsifiers used in production: slow cracking, medium cracking, and fast cracking. The emulsified asphalt used in micro-surfacing construction is slow cracking and fast setting cationic emulsified asphalt. This type of emulsified asphalt is prepared using slow cracking and fast setting asphalt emulsifier and adding polymer modifiers. It can achieve sufficient mixing time and quick setting effect. The adhesion between cations and stone is good, so the cationic type is chosen.
Slow cracking and fast setting micro surface emulsified asphalt_1Slow cracking and fast setting micro surface emulsified asphalt_2
Slow cracking and fast setting emulsified asphalt is mainly used for preventive road maintenance. That is, it is used when the base layer is basically intact but the surface layer is damaged, such as the road surface is smooth, cracked, rutted, etc.
Construction method: Spray a layer of adhesive oil first, then use a micro-surfacing/slurry seal paver to pave. When the area is relatively small, manual mixing and paving of emulsified asphalt and stone can be used. Leveling is required after paving. It can be used normally after waiting for the surface to dry. Applicable to: thin layer construction within 1 cm. If the thickness needs to exceed 1 cm, it should be paved in layers. After one layer is dry, the next layer can be paved. If there are problems during construction, you can contact customer service for consultation!
Slow-crack and fast-setting emulsified asphalt is a cementing material for slurry sealing and micro-surface paving. Strictly speaking, in the construction of modified slurry seal and micro-surfacing, slow cracking and fast-setting emulsified asphalt needs to be added with a modifier, that is, modified emulsified asphalt.