Usually, as long as we use the mixer in accordance with the regulations and in an appropriate manner, we don't have to worry about accidents. Today, the editor of Sinoroader Asphalt Mixing Station analyzes some situations that may occur in the mixer during work:

In order to achieve the direct supply of putty powder, the mixer runs at high speed, which causes the materials in the equipment to be thrown out of the equipment. This is normal, but if too much material is thrown out, it needs to be handled. There are roughly three reasons for the splashing of materials:
1. The gravel mix ratio is not good. The natural gravel particles in the mixer cannot use uniform-sized particles. Different sizes of particles should be mixed and matched. If uniform particles are used or the particles are not matched scientifically, splashing will occur. This kind of problem needs to be solved by adjusting the gravel mix ratio.
2. The construction method is wrong. It may be that the paint gun is too large or the paint gun pressure is too high, which causes the material to rotate faster and be thrown out of the equipment. It can appropriately reduce the working pressure and reduce the splashing of raw materials.
3. The poor consistency of architectural paint mortar. The poor consistency of architectural paint mortar will also cause sand to fall and splash during painting, which is a serious waste of raw materials. This problem can be solved by adjusting the mortar consistency of architectural paint.
The above is a brief summary of the editor of Sinoroader asphalt mixing station on the actual problems that may cause the splashing of raw materials during the operation of the mixer; I don’t know if you have read this article and it will be helpful to you.