Maintenance of bitumen melting equipment is crucial to the normal operation of the equipment, extending its service life and ensuring production safety. The following are some of the main maintenance measures:
Daily maintenance: During the operation of the equipment, it is necessary to regularly check the operating conditions of various parts of the equipment, including whether the motor, reducer, etc. have abnormal noise and vibration, and whether the connection parts are loose. At the same time, observe the melting of bitumen to ensure the normal operation of the temperature control system to prevent local overheating or uneven melting. After work every day, clean the dust, oil and bitumen residue on the surface of the equipment in time to keep the equipment clean.

Regular maintenance: Check the equipment at regular intervals (such as one month or one quarter). Check whether the heating pipes of the heating system are damaged or aged. If damaged, they should be replaced in time to ensure heating efficiency. Clean the impurities and sediments inside the bitumen storage tank to prevent excessive accumulation from affecting the quality of bitumen and equipment operation. Check and maintain the lubrication system of the equipment, and replace the lubricating oil regularly to ensure that all moving parts are well lubricated and reduce wear.
Seasonal maintenance: In winter, pay special attention to the insulation measures of the equipment, check whether the insulation layer is intact, and prevent the bitumen from solidifying due to low temperature, which will affect the normal operation of the equipment. In summer, pay attention to the heat dissipation of the equipment to avoid damage to the equipment due to long-term high-temperature operation.
Fault repair: Once the equipment fails, it should be stopped for inspection in time and repaired by maintenance personnel. After the repair, a trial run should be carried out to ensure that the equipment returns to normal. At the same time, the cause of the failure should be analyzed and summarized, and corresponding preventive measures should be taken to avoid similar failures from happening again.
Replacement of wearing parts: According to the use of the equipment, regularly replace wearing parts, such as agitator blades, seals, etc. The wear of these wearing parts will affect the performance of the equipment, and timely replacement can ensure the stable operation of the equipment.